Water Damage Restoration – The Facts? It is the process of repairing a house or property to its pre loss condition. Damage to the home could be because of an overflow, flood or any other water damage event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. There are 2 large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) and also the RIA (Restoration Industry Association) that recommends standards for water damage restoration. The S500 damage because of water guide is the benchmark tool that is used by companies focusing on restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the foremost and the most important step in water damage restoration. The assessment has to be correct so that the right response can be used. In restorating the harm brought on by water, technicians as well as the insurance firms must work together and know what is damaged and how to make restoring the damage. Identifying the cause in the damage, documentation of damage, and accurate estimates are mandatory for a proper water damage restoration. Categorization is based on the contamination amounts of the water source. The categories are listed below
Category 1 – This can be water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This can be water which has some contaminants like water from a dishwasher, washer or toilet with urine.
Category 3 – This can be water that is certainly highly unsanitary and can do causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are a few examples.
Decontamination and Drying – Following the evaluation is complete, the whole process of drying and decontaminating begins on the site. Based on the extent of damage, damage caused due to water can be classified into 4 types. Class 1 Damage- When loss is fixed to your small area and fewer water has been absorbed by materials. This results in slow evaporation rate. Class 2 Damage – When the damage is to the whole room and carpet area. Class 3 Damage – If the entire area is saturated with water and sophistication 4 Damage – when there are lots of deep saturation pockets. Decontamination and drying is really a key stage in Water damage and mold restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments need to be used. Decontamination must be done if contamination continues to be detected in the community. Decontamination may be performed for the entire area or perhaps in specific pockets where contamination has become detected.
Monitoring and Completion – Monitoring the restoration procedure of damage caused due to damage is crucial to obtain the desired results. One must be proactive through the monitoring process. Checking in the event the drying devices are setup properly, assessing in the event the personnel involved are qualified for the task and checking when the equipments will be in working order inwtsy all area of the monitoring process. Necessary steps have to be taken if something wrong is spotted through the monitoring process. The complete process of water damage and mold restoration will be considered complete only once the humidity, temperature and the moisture content is as per industry standards. Upon finishing of this type of water damage restoration process, the drying equipment can be removed.